Jump to content
  • Recently Browsing

    • No registered users viewing this page.

Computer Troubleshooting And Repair


Recommended Posts

B) miss, whats the nic driver...and how would i be able to determine if i have been affected by a malware...how would i be able to remedy this...thanks...(hirap talaga maging computer illiterate na puro net at type lang alam...hehehe...)... B)

 

 

there's probably a malware - rootkit or spyware attached to your nic driver..

Link to comment

B) miss, whats the nic driver...and how would i be able to determine if i have been affected by a malware...how would i be able to remedy this...thanks...(hirap talaga maging computer illiterate na puro net at type lang alam...hehehe...)... B)

 

 

 

 

do you have an onboard network card? If you do, what's your computer's motherboard?

 

Hmmm, checking for rootkit is quite tricky but you can start with running malwarebytes in safe mode.

 

or try this Running SDfix

 

For more info you'd probably wanna check www.bleepingcomputer.com

Link to comment

Sorry for the late rep, I haven't visited this thread for quite awhile.

 

Alright, hmm... Try to reset your router back to factory default by pressing that tiny hole for 10 seconds at the back of the router. It is usually found near the 4 ethernet ports. You'll notice the "1 , 2, 3, 4" on the router's front panel is blinking fast. Once is it doing that, it is now ok to release the button. After that, it should restart(you should not connect any devices to the router just yet). Unplug the power from your router for about 5 seconds, then plug it again.

 

On your PC's side, just set your Local Area Connection to dynamic.

 

Take your PCs other side of the ethernet cable and plug it into any of the four ports of the router. You should see the number on the router's front panel lit up. Now try to observe if your taskbar will give a pop up ballon that says "Local Area Connected".

 

Run a command prompt, then issuing ipconfig on the "C:/>" prompt. You should be getting 192.168.0.100 or 192.168.1.100 on your IP address. Check your default gateway, it should be either 192.168.0.1, 192.168.0.254, 192.168.1.1, or 192.168.1.254. Those are the common addressing schemes for home routers. Afterwards issue a "ping" command on the same command prompt, it should look like this "C:/>ping <inser default gateway IP>" or "C:/>ping 192.168.1.1" then press enter, you should see something like a reply, and not a "request timed out".

 

If you managed to get this far, just let me know.

 

 

I could give this to you screenshot by screenshot, just let me know what Operating system you are using

>stand alone friend u only use ping to check the connectivity of ur internet, go to network connections ryt click on ur lan network click properties, click internet protocol maual obtain the ip 192.168.1.1 tab 192.168.1.1 click ok, open a browser on the main browser type 192.168.1.1 viola!

Link to comment

I would like to put all my 100+ DVDs on a hard drive... what's the best and fastest free software to do it with?

 

No other way of doing it but creating a folder on your desktop(or anywhere else on your computer)then drag and drop all the files to that folder. It's just the same thing when your copying other types of file to your hard drive.

 

 

wink.gif

Link to comment

Guys,

 

I just want to ask for advice how to remove the WGA notification during PC start-up. I used pirated software when i installed my OS and thats the reason why it happened. Kindly give me solution(s) how to resolve this issue that's bothering me every start-up

 

Thanks in Advance!

 

then purchase a genuine OS cd :P

Edited by ativan
Link to comment

Good day!

 

Ask ko lang po kung may shop sa Gilmore or Greenhills na pede mag-access ng HDD ng laptop ko? Nabasag kasi last week and lumang modelo na ren. Tapos kanina may error ako nakuha nung kinabit ko sa ibang monitor "windows/system32/config//system". Gusto ko lang makuha yung files sa My Document if possible.

 

Thanks :)

Link to comment

Good day!

 

Ask ko lang po kung may shop sa Gilmore or Greenhills na pede mag-access ng HDD ng laptop ko? Nabasag kasi last week and lumang modelo na ren. Tapos kanina may error ako nakuha nung kinabit ko sa ibang monitor "windows/system32/config//system". Gusto ko lang makuha yung files sa My Document if possible.

 

Thanks :)

 

Hi :)

 

You just need to copy the missing files to the C:\windows folder (check this link http://support.microsoft.com/kb/307545 )or do a parallel installation of windows so that you can still access your files but then sometimes it's a sign that your hard drive is already busted.

Edited by SamanthaJones
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...