Jump to content
  • Recently Browsing

    • No registered users viewing this page.

Computer Troubleshooting And Repair


Recommended Posts

Have problem with my Blue M626 laptop.

 

Just recetly nagkaroon ng boot problem. GHere's the error

Error

0701: USB Over Current On HC/Port

 

Press <F1> to resume, <F2> to enter Setup

 

Pressing F1 would do nothing. I also found out that one of the USB is not functioning. Tried to configure CMOS Setting but still the error appears.

 

Thanks for any help that you guys can provide.

 

Try restoring your CMOS to default setup or if you know how to RESET a CMOS please do so.

The answer is already found in the error you posted.

It's either you changed something on the current passing through your USB port or when you plugged something on that USB port and made your laptop motherboard malfunctioned. Lucky for you if your laptop is still under warranty.

Edited by AuAu
Link to comment
Guys need your expert advice on how to configure smartbro share it router to do Port forwarding so i can DL faster using torrent

 

Basically, you need to access the router's GUI before you can set a Port Forwarding. Connect to the router and from your browser, key in on the address bar http://192.168.0.1 or http://192.168.1.1.

Port Forwarding usually can be found in NAT or Firewall settings of the router device. Key in your PC's IP address (with the torrent application) and the port of your torrent application. If there's an option like what protocol to use, choose BOTH (for TCP and UDP) transaction.

Link to comment
Basically, you need to access the router's GUI before you can set a Port Forwarding. Connect to the router and from your browser, key in on the address bar http://192.168.0.1 or http://192.168.1.1.

Port Forwarding usually can be found in NAT or Firewall settings of the router device. Key in your PC's IP address (with the torrent application) and the port of your torrent application. If there's an option like what protocol to use, choose BOTH (for TCP and UDP) transaction.

 

 

Hi thanks po for your advise but i need a more specific or step step procedure on this smartbro share it. before i can do Port forwarding in a separate modem and router but not like this one, i was hoping a more detailed solution using the smartbro share it interface. Sana you could help more... thanks po.

Link to comment

Eto ung steps:

 

1. open IE (or any browser for that matter)

2. access the router GUI (usually http://192.168.0.1 or http://192.168.1.1)

3. type in username and password to login

4. Look for something like "Advanced" (if you're using D-LINK)

5. Under sa port forwarding, Name = "Torrent".

6. public port and private port = <port na ginagamit ng torrent client m> (google m nlang kung papanu)

7. IP address = <ip address m> (start > run > cmd > ipconfig)

 

ung downloads m will go from 1-2kbps to 200kbps na siguro. Hope that helps!

Link to comment
Eto ung steps:

 

1. open IE (or any browser for that matter)

2. access the router GUI (usually http://192.168.0.1 or http://192.168.1.1)

3. type in username and password to login

4. Look for something like "Advanced" (if you're using D-LINK)

5. Under sa port forwarding, Name = "Torrent".

6. public port and private port = <port na ginagamit ng torrent client m> (google m nlang kung papanu)

7. IP address = <ip address m> (start > run > cmd > ipconfig)

 

ung downloads m will go from 1-2kbps to 200kbps na siguro. Hope that helps!

 

thanks po but the smartbro share it is different po .. sana marami p mag post regarding how to config. smartbro share it to port forwarding.

Link to comment
Guys need your expert advice on how to configure smartbro share it router to do Port forwarding so i can DL faster using torrent

what is your average download and upload rate for torrents? i'm a smartbro antenna-based internet subscriber too. i dont do port forwarding but my average download rate is 60kB/s per torrent. probably this is slow compared to wired DSLs and Ts but pwede na for me.

 

consider also the availability of the torrent and its seeders. depende rin kasi sa mga may file ng torrent kung pano nila configure dl/ul nila. see my post link below. this might help you to have a better torrent download. ;)

 

Maximizing Torrent Speed

Edited by -wet-
Link to comment
what is your average download and upload rate for torrents? i'm a smartbro antenna-based internet subscriber too. i dont do port forwarding but my average download rate is 60kB/s per torrent. probably this is slow compared to wired DSLs and Ts but pwede na for me.

 

consider also the availability of the torrent and its seeders. depende rin kasi sa mga may file ng torrent kung pano nila configure dl/ul nila. see my post link below. this might help you to have a better torrent download. ;)

 

Maximizing Torrent Speed

 

Bro. this is very helpful, pero wala b shorter way of configuring the smartbro share it? this is not a antenna based. before i can configure mine when i was a smartbro antenna based internet subs. pero ito bago sakin to, hope someone can provide one .. thanks a lot

Link to comment
...

 

Question for the Masters:

 

May na encounter akong laptop na yung hard disk ay di ko ma install-an ng XP. Na reformat ko na siya, kaso nga lang, tuwing susubukin ko mag install ng fresh copy ng XP, sa una, maglo load siya from boot-up. Then bigla na lang lalabas ang error na as if walang hard drive na naka install.

 

Anybody encountered this before? Any feedback would surely help. TIA!

 

na reformat mo ba using the same xp installer cd? if not, the laptop probably has a sata hdisk running in native mode; in which case, try fiddling around with the bios settings to disable sata native mode or enable ide mode or something to that effect. hth!

Link to comment
------------------------------------------------------------------

 

Question for the Masters:

 

May na encounter akong laptop na yung hard disk ay di ko ma install-an ng XP. Na reformat ko na siya, kaso nga lang, tuwing susubukin ko mag install ng fresh copy ng XP, sa una, maglo load siya from boot-up. Then bigla na lang lalabas ang error na as if walang hard drive na naka install.

 

Anybody encountered this before? Any feedback would surely help. TIA!

You need to integrate an ICH9 Driver to your Windows XP Installer. I'll bet that the laptop you're trying to downgrade to XP is using Windows Vista. :goatee:

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...