Google Posted February 5, 2009 Share Posted February 5, 2009 ako problem co how to un-install windows vistapara mabalik ko sa windows xp bwesit un nakuha cong copy ng vista alang hardware support. best thing is to reformat your pc and reinstall XP. Quote Link to comment
alloy v7.6 Posted February 5, 2009 Share Posted February 5, 2009 thanks po sa advise nyo malamang sa bayantel nga ito kasi maayus naman modem ko at mga line nito dati na kz nangyari ito at 2 months ko yata ito paulit-ulit itinawag sa kanila hanggan sa paitan yata nila yung socket ko sa box nila at umayus na. baka di sa mga hard drive yung problem sa pag crash ng pc ko kz 8 pc ko ganun ang problem mejo kakaiba naman yata sabay-sabay sila same symptoms. well thanks ulit d2 sana magawan ko pa ito ng solution w/o buying new drives. do you mean another person from installing to your pc? try deepfreeze Hmm, 8 units PC mo... Tapos sabay sabay...At naka Deep Freeze ka. You must be operating an internet shop. Deep freeze is indeed a remarkable software. Better than any antivirus since everything is restored to a pre-set restore point everytime you reboot. Ingat ka lang sa mga gumagamit ng anti-freeze. Pero it is most advisable talaga sa Internet shop environment. But it has its downside. Since laging nagre restore sa isang restore point every boot, mas madaling nagde degrade yung hard disk. Instead of it having 6 years of average effective life, nagiging 4 or less. Its a consequence. And since sabay sabay (approximately) binili at inooperate lahat ng 8 units, malamang nga na halos sabya sabay din bibigay yung hard drive. So, you'd just have to choose between risking infection and reducing it by installing a decent antivisur which is regularly updated or you could install Deep Freeze and reduce the average effective lifespan of your hard disks. IMHO, I'd install Deep Freeze and keep in mind that my HDs can break within three to four years at mag save na ng pamalit. Mas masakit sa ulo kapag puro virus lagi mga PC mo sa shop eh. Hehehe. Naalala ko nga pala bigla, naka encounter na nga pala ko nung. Frequent crashing na ganun din ang sintomas. Nakuha sa Reinstall ng Windows. Try mo. Baka gumana. Clarification lang po. Are you a girl or a boy? Kasi sabi sa Gender mo, female ka. Quote Link to comment
Google Posted February 6, 2009 Share Posted February 6, 2009 panu po i - convert yung internal CD ROM to external? may bibilhin po ba at saan? magkakaroon kasi ako ng laptop kaso walang internal CD ROM eh kaya di ko malalagyan ng windows. TIA :thumbsupsmiley: imho, walang facility or special device to convert your internal CD ROM to an external one.just buy an external DVD-RW drive. mura na lang din naman yun eh. USB connected. Quote Link to comment
rc36 Posted February 6, 2009 Share Posted February 6, 2009 MTC bros and sis, pls help me. i plan to buy a minilaptop like an asus or msi wind. based on this thread/subforum wla optical drive ang mga ito. My query is: is it technically possible to connect/ install an optical drive & play a dvd movie thereafter installation? TIA Quote Link to comment
sierrav3 Posted February 8, 2009 Share Posted February 8, 2009 Meron akong Hiren's Boot CD di ko alam na ganito pala kadami utilities nito. --------------------------------------------------------- BIOS Update Procedure All latest Motherboards today, 486/ Pentium / Pentium Pro etc.,ensure that upgrades are easily obtained by incorporating the system BIOS in a FLASH Memory component. With FLASH BIOS, there is no need to replace an EPROM component. Once downloaded, the upgrade utility fits on a floppy disc allowing the user to save, verify and update the system BIOS. A hard drive or a network drive can also be used to run the newer upgrade utilities. However, memory managers can not be installed while upgrading. Most pre-Pentium motherboards do not have a Flash BIOS. The following instructions therefore do not apply to these boards. If your motherboard does not have a Flash BIOS (EEPROM) you will need to use an EPROM programmer to re-program the BIOS chip. See your dealer for more information about this. Please read the following instructions in full before starting a Flash BIOS upgrade:A. Create a Bootable Floppy (in DOS) •With a non-formatted disk, type the following: format a:/s •If using a formatted disk, type: sys a: This procedure will ensure a clean boot when you are flashing the new BIOS. B. Download the BIOS file •Download the correct BIOS file by clicking on the file name of the BIOS file you wish to download. •Save the BIOS file and the Flash Utility file in the boot disk you have created. Unzip the BIOS file and the flash utility file. If you don't have an "unzip" utility, download the WinZip for Windows 95 shareware/ evaluation copy for that one time use from _www.winzip.com or _www.pkware.com. Most CD ROMs found in computer magazines, have a shareware version of WinZip on them. •You should have extracted two files: Flash BIOS utility eg: flash7265.exe (for example) BIOS eg: 6152J900.bin (example) Use the latest flash utility available unless otherwise specified (either on the BIOS update page or in the archive file). This information is usually provided. C. Upgrade the System BIOS During boot up, write down the old BIOS version because you will need to use it for the BIOS backup file name. Place the bootable floppy disk containing the BIOS file and the Flash Utility in drive a, and reboot the system in MS-DOS, preferably Version 6.22 •At the A:> prompt, type the corresponding Flash BIOS utility and the BIOS file with its extension. For example: flash625 615j900.bin •From the Flash Memory Writer menu, select "Y" to "Do you want to save BIOS?" if you want to save (back up) your current BIOS (strongly recommended), then type the name of your current BIOS and its extension after FILE NAME TO SAVE: eg: a:\613J900.bin Alternatively select "N" if you don't want to save your current BIOS. Beware, though, that you won't be able to recover from a possible failure. •Select "Y" to "Are you sure to program?" •Wait until it displays "Message: Power Off or Reset the system" Once the BIOS has been successfully loaded, remove the floppy disk and reboot the system. If you write to BIOS but cannot complete the procedure, do not switch off, because the computer will not be able to boo, and you will not be given another chance to flash. In this case leave your system on until you resolve the problem (flashing BIOS with old file is a possible solution, provided you've made a backup before) Make sure the new BIOS version has been loaded properly by taking note of the BIOS identifier as the system is rebooting. For AMI BIOSOnce the BIOS has been successfully loaded, remove the floppy disk and reboot the system holding the "END" key prior to power on until you enter CMOS setup. If you do not do this the first time booting up after upgrading the BIOS, the system will hang. BIOS Update Tipsnote:1.Make sure never to turn off or reset your computer during the flash process. This will corrupt the BIOS data. We also recommend that you make a copy of your current BIOS on the bootable floppy so you can reflash it if you need to. (This option is not available when flashing an AMI BIOS). 2. If you have problems installing your new BIOS please check the following: Have you done a clean boot?In other words, did you follow the above procedure for making a bootable floppy? This ensures that when booting from "A" there are no device drivers on the diskette. Failing to do a clean boot is the most common cause for getting a "Memory Insufficient" error message when attempting to flash a BIOS. If you have not used a bootable floppy, insure a clean boot either by a) pressing F5 during bootup by removing all device drivers on the CONFIG.SYS including the HIMEM.SYS. Do this by using the EDIT command. Have you booted up under DOS?Booting in Windows is another common cause for getting a "Memory Insufficient" error message when attempting to flash a BIOS. Make sure to boot up to DOS with a minimum set of drivers. Important: Booting in DOS does not mean selecting "Restart computer in MS-DOS Mode" from Windows98/95 shutdown menu or going to Prompt mode in WindowsNT, but rather following the above procedure (format a: /s and rebooting from a:\). Have you entered the full file name of the flash utility and the BIOS plus its extension?Do not forget that often you will need to add a drive letter (a:\) before flashing the BIOS. Example: when asked for file name of new BIOS file which is on your floppy disk, in case you're working from c:\ your will need to type a:\615j900.bin, rather than 615j900.bin only. Quote Link to comment
alloy v7.6 Posted February 9, 2009 Share Posted February 9, 2009 MTC bros and sis, pls help me. i plan to buy a minilaptop like an asus or msi wind. based on this thread/subforum wla optical drive ang mga ito. My query is: is it technically possible to connect/ install an optical drive & play a dvd movie thereafter installation? TIA Dude, technically, its very possible. Kung mag burn nga, possible eh. Playing movies pa kaya? Just make sure you have the right software to play the movies with like Nero Showtime, etc. And also make sure that your External CD/DVD R/W drive comes with drivers. Yung lang nakikita kong posibleng magka problema. Pero kung bago naman ang bibilhin mo, malamang, kahit walang kasamang driver, may available na driver sa website niya. Just check the package of the product. Quote Link to comment
crunchy_blac666 Posted February 9, 2009 Share Posted February 9, 2009 pano ba dagdagan shared memory ng Video onboard ko? sa BIOS ba ginagawa un? bagong asrock board ko... TNX Quote Link to comment
Google Posted February 10, 2009 Share Posted February 10, 2009 pano ba dagdagan shared memory ng Video onboard ko? sa BIOS ba ginagawa un? bagong asrock board ko... TNX if your video card is integrated, you cannot do it over the bios. get a better video card na lang. Quote Link to comment
generalz Posted February 11, 2009 Share Posted February 11, 2009 Guys ask ko lang po about sa game na nainstall ko, Left4dead sya sa isa kong pc ok naman kaso sa other pc naman sounds lang sya wala yung video pero halos same spec lang naman pc k ano kaya problem d2? Quote Link to comment
Google Posted February 11, 2009 Share Posted February 11, 2009 Guys ask ko lang po about sa game na nainstall ko, Left4dead sya sa isa kong pc ok naman kaso sa other pc naman sounds lang sya wala yung video pero halos same spec lang naman pc k ano kaya problem d2? baka sa video rendering yan ng game. try to change muna the monitor settings ng computer mo. start from 640 x 480 and go upwards if needed. Quote Link to comment
ron2b1l Posted February 11, 2009 Share Posted February 11, 2009 i have a poblem with my notebook....nag blue screen siya pag nag install ako ng bagong os..... may service center ba ng gateway ba d2 sa pinas? guys help!!!!!!! alam ko d ito related sa topic.. pero ask ko lang.. i hav a prblem kc s fs account ko.. binago kc ng x ko ung password so d ko sya mapasok.. any idea guys pno ko ma retrieved ung fs account ko?? tnxssss Quote Link to comment
YAKABUD Posted February 11, 2009 Share Posted February 11, 2009 guys help!!!!!!! alam ko d ito related sa topic.. pero ask ko lang.. i hav a prblem kc s fs account ko.. binago kc ng x ko ung password so d ko sya mapasok.. any idea guys pno ko ma retrieved ung fs account ko?? tnxssss use the forgot password option just enter the email address you have used to register with Friendster and a link will be sent to that email address to reset your password Quote Link to comment
mightbeyou Posted February 22, 2009 Share Posted February 22, 2009 :goatee: is there any remedy for my drive c and drive d aside from reformat since everytime i double click on the drives it asks for what program to use to open the drive instead of the usual opening of the drive automatically...so instead of being able to access the drive immediately i still have to choose explore in the right click menu for me to be able to view the contents of the drive...what could i do about it...thanks... :goatee: Quote Link to comment
Google Posted February 23, 2009 Share Posted February 23, 2009 :goatee: is there any remedy for my drive c and drive d aside from reformat since everytime i double click on the drives it asks for what program to use to open the drive instead of the usual opening of the drive automatically...so instead of being able to access the drive immediately i still have to choose explore in the right click menu for me to be able to view the contents of the drive...what could i do about it...thanks... :goatee: walang problem yung drives mo inho. ang problem mo is yung windows mo.try mo muna mag XP repair. Quote Link to comment
MisterYozo Posted February 27, 2009 Share Posted February 27, 2009 question... is it ok to install RAM from different manufacturer when upgrading memory?will it not cause any conflict or issue? thanks Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.